"Wally" wrote
Worth sitting down to with a brew.
... but if you are considering this route I wouldn't hesitate to
recommend Phil Ramsey of http://www.bluebellaudio.com/ for bits and
bobs at a *very* reasonable rate including Hammond iron at decent
prices, if you decide not to roll yer own. (Audio Note as well, I
gather, for those with deep pockets....??)
I think I need to build up a list of links...
This is my 'Vinyl Links' page (unfinished of course) - fill yer boots.....
(Nick G might want to see the very first link I put on it some 18 months
ago! ;-)
Then go he
http://www.worldtubeaudio.com/
.....and give yourself a thrill!
(Check out the World Bike and Car Portal links while you're there - summat
for everyone! :-)
Hole punches for transformers? Like, big square shapes?
No, but nothing to stop you using them for 'starter holes' is there???
If anyone does contact him, mention this ng - he didn't seem aware of
it and was pleased to hear there are still some genuine enthusiasts
(idiots) about!
(Might get a 'group disount or summat!! ;-)
I'll keep that in mind, but I have a pre-amp tart-up and a speaker rebuild
fantasy to cater for first. ;-) I'm gravitating towards making a
prototype
of the tapered tube enclosure fairly soon - rather than spend far too long
trying to understand the theory of it, I'm just going to make one to the
dimensions that the artist in me decided looked right - I'll work out what
direction it has to go in once I hear it.
Yes, I'm kinda going to adopt a 'do it, then try and understand it' approach
to my own project....!!!